Newstar NSUSB421A Manual de usuario descargar pdf (Pagina 8)

NS-USB421A

FCC Certifications

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interfer-

ence by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation distance between the

equipment and receiver.

Connect the equipment to an outlet on a circuit different

than that of which the receiver is connected to.

Consult the dealer or an experienced radio/TV

technician for help.

Shielded interface cables must be used in order to

comply with emission limits.

Troubleshooting

The Auto Switch does not detect my computer.

1.Check that the USB cable between the Auto Switch and

the computer is properly connected.

2.Make sure the connected computer is not further than

15 feet away.

3.Check that the USB cable between the Auto Switch and

the computer is no longer than 15 feet.

4.Try connecting the computer to a different port.

5.Restart the computer and repeat installation

My USB peripheral device is not detected by the AOD

Switch software

1.Make sure the required drivers are installed and that the

USB device supports the operating system.

2.Make sure the connected computer is no further than 15

feet away.

3.Make sure the connected USB device is no further than

15 feet away.

4.Check that the cable between the Auto Switch and the

device is no longer than 15 feet.

5.Close the AOD software and re-open the application

according to installation instructions.

1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios

Newstar NSUSB421A Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Cubos de interfaz Newstar NSUSB421A